Cleaning white fiberglass interior of boat that has alot of dirt and light mold on surface - -? - cleaning mold from boat cushions
I'm sure there are many boats the whole time with their boats - even if they fall, that they are from a time not discovered or developed, the layer of fiberglass / white dust and dirt, with patches of black mold, even where moisture accumulates. After a very wet rainy summer here, my boat is kept at a storage bin of the Earth (Discovery, I know, stupid DUH) - for about 2 months - the opening of a center console fishing boat about 20 'interiror long, smooth white fiberglass, center console, front and rear seat console. Typical design. But the whole inner surface is covered with a layer of mud covered with dirt nasty dirty and mold now. It's a fucking disaster. I know I can only begin with the hose and brush an inch at a time, but there is no way to safely spray solution preparation throughout the interior clean to drink, and begin to unravel part of this form / Grime. I know, maybe you can have any kind of use of clean, warm water and chlorine in the water - but the gelcoat is newThis boat cushions and soft white faux leather, I do not dare to use a strong detergent or bleach, as is too easy to permanently damage the surface. Any suggestion is welcome. It is a balancing act between the dirt and not damage sensitive surfaces such as gel coat and upholstery vinyl. It is without doubt one of the most common challenges to all of the cleaning of a ship, from time to time - any help is greatly appreciated!
Cleaning Mold From Boat Cushions Cleaning White Fiberglass Interior Of Boat That Has Alot Of Dirt And Light Mold On Surface - -?
Thursday, February 4, 2010
|
Subscribe to:
Post Comments (Atom)
4 comments:
I Was there a rule with bleach, especially when it comes to form. Some aerosols, such as X-14 mildew chlorine in them and are very strong. Cleaning with Clorox (green, not blue) works very well and never had a problem with the old or new gelcoat. You spray it on, let sit for at least 30 seconds, then with a clean damp cloth to move the dirt and hose. Working in areas that do not, it takes a long time. put the brush in areas that are really bad, then again with the rag
Rinse everything went well at first, then you might with a mild detergent such as 409, spray nine fantasy start or orange, which is clean for the most part, except stronger and green full strength bleach for easy or difficult areas and forms.
I have no problems with the vinyl and spray bleach, if it should be no longer than 30 seconds to a minute, and as you are know to be good.
Toilet bowl (thickest available have one) and use a drive-through washing system for washing vehicles. Use your brush. I even used an engine degreaser to clean bilge water. You also have the opportunity to wash wand to reach awkward places. Any good vinyl cleaner upholstery.
This product is not as clean and protect the f.glass === I ask for the boat dealer in the marine environment, "BRITE BOY" "= good things, and it worked only every other product, it will take to do and could not ..
It is a soap boat and kill the form available in every port, but as you have said a combination of bleach and it works well, water and cause no damage to the gelcoat. For platelet I recommend a vinyl cleaner.
Post a Comment